GE MDS entraNET 900 Technical Manual page 115

05-4055A01, Rev. E
—Sets or displays the
DEFAULT=<mode>
startup. cannot be set to
DEFAULT
authorized for serial payload.
:
COM1
CONSOLE
: defaults to transparent data mode.
COM1
DATA
: defaults to in Basic Serial Protocol mode.
COM1
BSP
:
COM1
INT_LOOP
:
COM1
EXT_LOOP
—Sets or displays the
FORMAT=<format>
parity, and stop bits setting. Valid data parameters are:
—seven char bits, no parity, one stop bit
7N1
—seven char bits, no parity, two stop bits
7N2
—seven char bits, odd parity, one stop bit
7O1
— seven char bits, odd parity, two stop bits
7O2
—seven char bits, even parity, one stop bit
7E1
—seven char bits, even parity, two stop bits
7E2
—eight char bits, no parity, one stop bit (default setting)
8N1
—eight char bits, no parity, two stop bits
8N2
—eight char bits, odd parity, one stop bit
8O1
—eight char bits, odd parity, two stop bits
8O1
—eight char bits, even parity, one stop bit
8E1
—eight char bits, even parity, two stop bits
8E2
NOTE: Entering data formats other than those listed above might
cause undesired operation.
—Sets or displays the Group ID that this transceiver
GROUP=<ID>
belongs to at the AP, for purposes of serial data multicasting (0-15).
—Sets or displays the transceiver inter-packet gap status.
INTERGAP=
Optional arguments:
—For incoming and outgoing serial data.
IO
—For incoming serial data only.
IN
—For incoming and outgoing (low latency) serial data.
IOL
—For incoming (low latency) serial data only.
INL
—Sets the console port interface mode.
MODE=<mode>
set to unless the device has been authorized for serial payload. To
DATA
escape from data mode, enter three consecutive + characters to
with at least 100 ms between entries.
—Places
CONSOLE
—Places
DATA
—Places
COM1
BSP
—Places
INT_LOOP
—Places
EXT_LOOP
MDS entraNET Technical Manual
COM1
unless the device has been
DATA
defaults to command-line mode.
defaults to internal loopback mode.
defaults to external loopback mode.
COM1
in command-line mode.
COM1
in transparent data mode.
COM1
in Basic Serial Protocol mode.
in internal loopback mode.
COM1
in external loopback mode.
COM1
port default mode on
port data characters,
cannot be
MODE
COM1,
105