Page 1
!i!!i!!i!!i!!i!!i! Life's Good Please read these instructions thoroughly before installing and operating range_ LRE3025ST LRE3023ST LRE3025SB LRE3023SB LRE3025SW LRE3023SW Pr nted on 100% Recyc ed Paper MFL57205804...
TABLE OF CONTENTS TABLE OF CONTENTS SAFETY Before You Begin Important Safety Instructions Prepare to Install the Range PREPARE INSTALL RANGE Installation Drawings ELECTRICAL CONNECTIONS Electrical Connection Requirements Connect Range Cord 3-Wire Connection With a Power Supply Cord 4-Wire Connection With a Power Supply...
Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. You can download the installation and owner's manual at: http://www.lg.com. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent...
Page 4
SAFETY FAWARNING . Power supply cord and plug should not be modified. If it will not fit the outlet, have a proper outlet Installed by a qualified electrician, . Using an extension cord to connect the power is prohibited. The way to connect the power cord and plug directly isstrongly recommended.
SAFETY PREPARE TO INSTALL THE RANGE _----A WAR N ING information in this manual should TOOLS NEEDED followed exactly. - A fire or electrical shock may result causing Phillips Screwdriver Level property damage, personal injury or death. FAWARNING Flat-blade • Any person should step Adjustable...
PREPARE TO iNSTALL THE RANGE INSTALLATION DRAWINGS -@ NOTE SAVE FORTHE USE OFTHE LOCAL ELECTRICAL INSPECTOR CLEARANCES AND DIMENSIONS (Figure To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than 15/32 (12mm) from any adjacent surface.
ELECTRICAL CONNECTIONS 7 ELECTRICAL CONNECTION CONNECT RANGE CORD REQUIREMENTS The Rear Access cover must be removed. Loosen three screws with a screwdriver. The terminal block will This appliance must be installed and grounded on a then be accessible. branch circuit by a qualified technician in accordance...
Page 8
ELECTRICAL CONNECTIONS 3-WIRE CONNECTION WITH A POWER SUPPLY CORD t----AWARNING , The middle (neutral or ground} wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main Cord strain relief terminal block.
ELECTRICAL CONNECTIONS 4-WIRE CONNECTION WITH 3-WIRE CONNECTION: CONDUIT A POWER SUPPLY CORD Install the conduit as follows: _-AWARNING Remove the Conduit connection plate from the rear of lower oven and rotate it as shown in Figure 5. The • Only a 4=conductor power-supply cord kit rated conduit...
10 ELECTRICAL CONNECTIONS 4-WIRE CONNECTION: CONDUIT 1. Follow the instructions under "Install the conduit 4-wire connection follows" on page 8 to correctly install the strain reliefl Black White Red DO NOT install the conduit without a strain reliefi I!1! //7// Terminal 2.
iNSTALL THE RANGE Replace the access cover on the back of the range, To replace the wire cover, insert the two tabs into openings located below the opening and tighten three screws, Access cover leveler Raise range Use a level to check your adjustments.
Page 13
Life's Good For inquires or cor'nmenfs, visit www Ig.cor-n or c_-'dJ 1-800-243-0000 USA, Consum÷_ Us÷_ 1-888-54,2-2623 o_s, rxl,_s, Pr nted on 00% Recyc ed P_pe Pdnted in Korea...