D-Link DMC-1001 - Power Supply - hot-plug User Manual page 3

I
NSTALLATION
Step 1: Connect the supplied AC power cord to the back of the
chassis.
Step 2: Attach the plug into a standard AC outlet with a voltage
range from 100~240Vac.
Step 3: Turn on the chassis system by flipping the switch beside the
receptacle to ON position. The LED on the front panel of
power supply will come on then.
.
Installing and Removing the Power Supply
To remove a power supply out the chassis, you have to loose
the hand screw counter clockwise and pull out the power
supply from the chassis.
To install a power supply to the chassis, you have to fasten
the hand screw clockwise and slide in the power supply to
the chassis.
You c a n slid e in a nd out the p ower sup p ly from the b ay,
fa sten or loose the ha nd sc rew c loc kwise or c ounter
c loc kwise b y using hand or sc re wdriver.
Attention!
If the Chassis System needs to work alone, you can
stick up four Rubber foot below the chassis!
3