Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
5.2
Installing Drive Enclosures
Optional drive enclosures can be installed while the ETERNUS DX Disk storage system is run-
ning without affecting the system.
This section explains how to install optional drive enclosures.
5.2.1
Installation Rules for Drive Enclosures
Only one drive enclosure can be connected to a 3.5" type controller enclosure.
Drive enclosures cannot be connected to 2.5" type controller enclosures.
5.2.2
Installable Drive Enclosures
For installable drive enclosures, refer to "Product List".
5.2.3
Drive Enclosure Handling Instructions
■
About condensation
■
About static electricity
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Do
CAUTION
•
When moving a drive enclosure from a cold place, such as an un-
conditioned store house in winter, to a warmer place such as an air-
conditioned room, the severe temperature change may result in
condensation forming.
To avoid this, allow the packed drive enclosures sufficient time in the
warmer place (one hour for each 15°C of temperature difference) to
adapt to the new temperature.
Do
CAUTION
•
When handling drive enclosures, make sure to wear a wrist strap or
touch a metal part to discharge the human body's natural static
electricity. Failure to discharge static electricity may cause device
failure.
Copyright 2013 FUJITSU LIMITED
63
P3AM-5512-05ENZ0