Installation/Configuration Notes - Bosch 200 Series Manual

3 | AutoDome 200 Series PTZ Camera System
The AutoDome 200 Series has advanced, built-in
diagnostics to simplify service and minimize
downtime. Using the On Screen Display (OSD), a
technician can quickly and easily check critical
parameters (such as internal temperature and input
voltage level) to verify that the dome is functioning
within acceptable operating limits. If video is not
present, a local inspection of three diagnostic LEDs at
the camera site can identify the presence of video and
control data.
Feature Comparison Matrix
The following table provides an overview of the
AutoDome camera family and its available features:
AutoDome AutoDome
Standard Features
100 Series 200 Series
Interchangeable Modules
High Speed PTZ
Preset Shots 64
Preset Tour
Guard Tour
Alarm Inputs
High Resolution Camera
Day/Night Operation
IR Sensitive
SensUp Extended Sensitivity
UTP/Coax Transmission
Hybrid Analog/IP Connectivity
Bilinx Remote Configuration*
Cable Compensation
Hot-Swap Camera Modules
Ruggedized, Vandal-Resistant Enclosure
Advanced Features
AutoTrack II Motion Tracking
Video Motion Detection
Image Stabilization
Privacy Masking and Sector Blanking
Advanced Alarm Control
*Compatible over Coax and UTP transmission only. Remote configuration over IP via web
interface.
Certifications and approvals
Electromagnetic Complies with FCC Part 15, ICES-003, and CE
Compatibility (EMC) regulations, including EN50130-4 and
EN50121-4
Product Safety Complies with CE regulations, UL, CSA, EN,
and IEC Standards
Region Certification
Europe CE EMC Directive, Low-Voltage Directive
AutoDome AutoDome
300 Series 500i Series
99 99
7/4 7/4

Installation/configuration notes

Ordering Guide
1 Video Format
1 PTZ PAL
2 PTZ NTSC
2 Camera Type
1 18x Color PTZ
3 Enclosure
C In-ceiling 2
P Indoor Pendant
E Outdoor Pendant
4 Bubble
C Clear Rugged
T Tinted Rugged
5 Communications
S Standard Analog (Coax/
UTP)
E Ethernet (TCP/IP)
1 No transformer included. Customer must supply an approved 24 VAC limited power
supply (VG4-A-PSUx or equivalent).
2 Recessed in-ceiling housing units do not require kit options for reference numbers 6, 7,
or 8.
3 Fiber optic option is multi-mode with biphase. Requires LTC 4629 at the system.
4 Roof mount mounts to vertical Parapet. For flat roof installation, order an additional
LTC 9230/01 Flat Roof Adapter Plate.
5 Optional trim skirt available as a separate purchase.
Technical specifications
Camera 18x Color
Imager 1/4 in. Exview HAD CCD
(752 x 582 PAL)/(768 x 494 NTSC)
Lens 18x Zoom (4.1–73.8 mm)
F1.4 to F3.0
6 Power
5
0 24 VAC
1
1 120 VAC
2 230 VAC
7 Mount
W Wall
M Mast
C Corner
R Roof
4
P Pipe
8 Fiber Optics
_ No Fiber
F Fiber
3