INSTALLATION
Re-crimp Procedure
In order to use accessories (RLN4858 and GKN6272) with the rear connector of the radio, please
follow the re-crimp procedure using the crimp pins provided with PMLN5072 connector kit.
1.
Cut and remove nickel plated pins from wire.
2.
Strip the insulation from the end of the wires (2mm to 4mm).
3.
Place the new gold plated crimp pin (from the PMLN5072 kit) on the gauge slot on the crimp
tool.
4.
Insert wire into wire slot of the crimp pin.
5.
Apply pressure to the crimp tool handle, until wire is crimped by the pin.
MTM5400 Mobile Terminal Installation Manual
These accessories do not require to be re-crimped when used
with the Junction Box GMLN5089.
61