SET DATE
Command:
SET DATE MMDDhhmm [[CC]YY][TZ]
Description:
Sets the date of the complex with the following definitions:
◦
MM: Month
◦
DD: Day
◦
hh: Hour (24-hour time)
◦
mm: Minute
◦
CC: Century
◦
YY: Year
◦
TZ: Time zone
If you leave the time zone variable blank, then the current time zone is left in effect.
Access level/Bay level:
OA Administrator, OA Operator
Restrictions:
◦
You must be connected to the monarch OA.
◦
Date and time can only be set if NTP is disabled.
◦
MM is an integer from 01 to 12.
◦
DD is an integer from 01 to 31.
◦
hh is an integer from 00 to 24.
◦
mm is an integer from 00 to 60.
◦
For valid time zones, see
SET NTP PRIMARY
Command:
SET NTP PRIMARY <ip address>
Description:
Sets the primary server used for synchronizing time and date using the NTP protocol
Access level/Bay level:
OA Administrator, OA Operator
Restrictions:
◦
You must be connected to the monarch OA.
◦
The <ip address> must be in the form ###.###.###.###, where each ### ranges
from 0 to 255.
94
Complex management commands
"Time zone settings" (page
207).