After Each Use; Cleaning Inlet Filter; Cleaning Nozzle Assembly; Detergent Delivery - Craftsman 559.741710 Owner's Manual

Before carrying out maintenance work, disconnect the plug from the electrical
power supply, and shut off the water supply.
The warranty on this pressure washer does not cover
items that have been subjected to operator abuse or
negligent. To review full value from the warranty, the
operator must maintain the pressure washer as
instructed below.

AFTER EACH USE

• Flush detergent siphoning tube with fresh water.
• Disconnect water inlet hose and inspect / clean the
inlet filter.
• Clean nozzle assembly.
• Wipe hose, cord assembly unit to remove dirt, oil
etc.

PRESSURE

The pressure is not adjustable.

PUMP

The pump is sealed and does not require any
lubrication.

HOSE

Replace leaking fittings and hose. Do not attempt to
repair, as they are designed to carry high pressure.

DETERGENT DELIVERY

The flow rate is set at 0.2 GPH and is not adjustable.
No adjustments should be made to any parts that are sealed.
10

CUSTOMER RESPONSIBILITIES

SERVICE AND ADJUSTMENTS

CLEANING INLET FILTER

The water inlet to the washer is protected by a filter
which should be checked and cleaned if it is found to
be dirty.
- Disconnect water inlet hose.
- Pull out internal filter.
- Clean filter.
- Reinstall filter.

CLEANING NOZZLE ASSEMBLY

- Disconnect the spray wand from the trigger gun.
- Remove dirt from nozzle bore with needle and
rinse with water from nozzle end.
- Reinstall

REPAIR PARTS

IMPORTANT:
The use of other than original spare parts could
lead to faults and even to serious accidents if
such parts are not properly manufactured or if
they do not exactly replace the original part.
If only original spare parts are used, you can be sure
that your unit will also work safely and without trouble
in the future.
For replacement parts information and ordering call
1-800-366-7278.