Expansion Cl Module Leds - HP ProCurve 6400cl Installation And Getting Started Manual

Introducing the Switch
Front of the Switch

Expansion cl Module LEDs

Expansion cl Module LEDs refer to the LEDs specific to the expansion
module. These LEDs are located on the physical expansion module bulkhead.
These LEDs are only viewable in the rear of the Switch on the Expansion
Module itself.
Table 1-3.
Name Color
Expansion Module LEDs per module
Module Green
Power
(ports A & B)
Module
Orange
Fault
(ports A & B)
Expansion Module LEDs per port
Link Green
Activity Green
C a u t i o n
It is recommended the power to the switch be removed before inserting or
extracting the expansion module. If the expansion module is inserted or
removed with the switch powered on, a reset will occur. Only install or remove
these modules during scheduled downtime.
1-8
Expansion cl Module LEDs
Mode Description
On Expansion cl module is plugged into expansion slot and operating
correctly
Off
Expansion cl module's power has been turned OFF, and the card can be
removed from the box if necessary.
On
Expansion cl module is plugged into expansion slot but has experienced
a fault
On Indicates the port LEDs are displaying link information:
• if the port LED is on, the port is enabled and receiving a link indication
from the connected device.
• if the port LED is off, the port has no active network cable connected,
Off
or is not receiving link beat or sufficient light. Otherwise, the port may
have been disabled through the switch console, the web browser
interface, or ProCurve Manager.
Blinking
• if the port LED is blinking* simultaneously with the Fault LED, the
corresponding port has failed its self test.
On Indicates the port LEDs are displaying network activity information.