Replacing The Palm Rest - Dell Studio 1555 Service Manual

1 screws (10) 2 power button connector
3 touch pad connector 4 display cable connector
5 camera cable connector 6 speaker connector
9. Carefully lift the palm rest along the rear edge, near the hinge brackets, then gently lift the palm rest to remove it from the computer.
Replacing the Palm Rest
1. Align the palm rest with the base of the computer and gently snap it into place.
2. Replace the ten screws on the palm rest.
3. Connect the touch pad cable and speaker cable to the respective system board connectors.
4. Connect the display cable, camera cable, and power button cable to the respective system board connectors (see
5. Slide the antenna cables through their cable routing (see
6. Replace the Mini-Cards (see
7. Replace the eight screws at the bottom of the computer.
8. Replace the base cover (see
Back to Contents Page
Replacing the Display
Replacing the Mini-Card).
Replacing the Base Cover).
Assembly).
Replacing the Display Assembly).