Asus DS300j G2 Series User Manual page 155

v ScSI P I
IewInG I ortal nformatIon
To view information for an iSCSI target port:
1. From the Main Menu, highlight iSCSI Management and press Enter .
2. Highlight iSCSI Portals and press Enter .
The list of portals appears.
3. Highlight the port you want to see and press Enter .
The portal information screen displays. Information includes:
• PortalID – Portal number. Starts at 0.
• TcpPort – TCP port number. 3260 is the default and recommended number.
• DHCP – Enabled or disabled.*
DHCP is currently supported only for IPv4.
• AssociatedType – PHY, VLAN, or Trunk.
• ControllerID – RAID controller ID, 1 or 2.
• PortID – Physical port on the RAID controller, 1 to 4.
• InterfaceName – device name.
• ProtocolFamily – IPv4 or IPv6.*
• PrimaryIP – Primary IP address of this portal.*
• Gateway - Gateway IP address of this portal*
• PrimaryIPMask – Subnet mask of this portal.*
• AssignedTarget – 0 is the default target. The number of targets available depends
on how many targets you create. See Adding iSCSI Targets (CLU) below.
Items marked with an asterisk (*) are adjustable under "Making iSCSI Portal Settings (CLU)" on page
149.
a ScSI P (clu)
DDInG I ortalS
ASUS DS300f G2 supports up to 32 iSCSI portals. Each iSCSI portal can belong to a different VLAN for a
maximum of 32 VLANs.
If you plan to associate the new portal with a trunk, create the trunk first. See "Adding iSCSI Trunks (CLU)" on
page 153.
For more information about iSCSI VLANs, see "iSCSI on a VLAN" on page <?>.
To add an iSCSI portal:
1. From the Main Menu, highlight iSCSI Management and press Enter .
149
(clu)
2. Highlight iSCSI Portals and press Enter .
The list of iSCSI Portals displays.
3. Highlight Create New Portal and press Enter .
4. Highlight AssociatedType and press the Spacebar to toggle through Physical, VLAN, and Trunk.
5. If you chose:
• PHY – Choose a Controller ID (1 or 2) and a Port ID (1 to 4).
• Trunk – Choose a Trunk ID (1 to 8).
To change an ID number, highlight the item, press Backspace to delete the current ID and type a new
ID.
6. If you use Associated PHY, highlight EnableVLAN and press the Spacebar to toggle between Enable and
Disable. If you choose Enable, enter a Vlan Tag (1 to 4094).
To change a value, highlight the item, press Backspace to delete the current value and type a new value.
7. Highlight Save Settings and press Enter .
The new Portal is added to the list.
m ScSI P S (clu)
akInG I ortal ettInGS
To make portal settings:
1. From the Main Menu, highlight iSCSI Management and press Enter .
2. Highlight iSCSI Portals and press Enter .
The list of portals displays.
3. Highlight the portal you want to change and press Enter .
The portal information screen displays.
4. Highlight iSCSI Portal Settings and press Enter .
5. Make changes as needed.
• DHCP – Enabled or disabled
DHCP is currently supported only for IPv4.
• ProtocolFamily– IPv4 or IPv6
• PrimaryIP – Primary IP address of this portal
• PrimaryIPMask – Subnet mask of this portal
• Gateway - Gateway IP address of this portal
DS300f G2 Series User Manual