Table of Contents
Advertisement
(Continued)
RESETTING THE MICROCOMPUTER
ON/
STAND-BY
TRANSPORTING THE UNIT
ON/
STAND-BY
CD
Headphones
Before plugging in or unplugging the headphones, make sure
the volume level is reduced.
Be sure your headphones have a 3.5 mm (1/8") diameter plug
and are between 16 ohms and 50 ohms impedance. The rec-
ommended impedance is 32 ohms.
When headphones are connected, the speakers are discon-
nected automatically. Adjust the VOLUME control for the
desired volume.
Reset the microcomputer under the following conditions:
X-BASS/
To erase all of the stored memory contents (clock and timer
DEMO
settings, and tuner and CD presets).
If the display is not correct.
If the operation is not correct.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Whilst pressing down the
button, hold down the ON/STAND-BY button for at least 1
second.
"CLEAR AL" will appear.
Caution:
The operation explained above will erase all data stored in
memory including clock and timer settings, and tuner and CD
presets.
Before you move this product to a new location, proceed
OPEN/
as follows:
CLOSE
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
Remove all CDs inserted in the unit.
4
Press the OPEN/CLOSE button to close the disc tray.
Make sure that "NO DISC" is displayed.
5
Press the ON/STAND-BY button to enter the stand-by mode,
and then unplug the AC power lead from the AC socket.
E-23
0
button and the X-BASS/DEMO
Advertisement
Table of Contents
