Miele H 136 MB Operating Instructions Manual page 53

Problem solving guide
Repairs to this appliance should
only be carried out by a suitably
qualified and competent service
technician approved by Miele. Un-
authorised repairs could be dan-
gerous.
The following can be corrected without
calling the Miele Service Department:
Check whether:
– the appliance is correctly plugged in,
– the mains fuse has blown (call the
Service Department),
Check whether:
– if operating in microwave mode the
appliance door is properly shut,
– if operating in microwave mode a
power setting and time have been
entered.
The halogen bulb needs replacing.
Replace it with a new one as follows:
Disconnect the appliance from the
electricity supply, (switch off and un-
plug at the socket, or remove the
fuse, or switch off at the isolator as
appropriate).
Loosen and remove the lamp cover
(1.). This may be easier using a rub-
ber glove.
Take out the halogen lamp (2).
Fit a new halogen lamp.
Connection data for halogen lamp:
12 V, 10 W
Temperature resistant to 300 °C,
W271 socket, Osram, Type 64418
The pins must lie horizontally to the ap-
pliance. Push the lamp in until it en-
gages.
Screw the lamp cover back on.
Reconnect the appliance to the
mains supply.
Check whether:
– the cooking process has been inter-
rupted and was not re-started,
– if cooking / reheating in microwave
mode the correct time was selected
for the setting chosen.
A lower power setting normally re-
quires a longer time.
53