Advertisement
STEP 5:
(SEE FIGURE 5)
*
Lock the drawbar into position by inserting a 3/8" x
3" pin (20) into the center hole and securing it with a
small 3/32" hairpin cotter (19).
STEP 7:
(SEE FIGURE 7)
*
Slide the bag frame tube (1) through the front flap in
the bottom of the bag.
*
Slide the two lower hopper tubes (10) into the flaps at
the front of the hopper bag (3) as shown.
FIGURE 5
FIGURE 7
STEP 6:
(SEE FIGURE 6)
•
Attach the hitch bracket (12) and straight hitch
bracket (13) to the drawbar using two 5/16" x 2-1/2"
hex bolts (15) and 5/16" nylock nuts (21).
Assemble the hitch pin (35) and two spacers (22)
to the hitch brackets. Secure them in place with the
large 3/32" hairpin cotter (18).
FIGURE 6
STEP 8:
(SEE FIGURE 8)
*
install a rear hopper tube (11) onto the ends of the
lower hopper tubes (!0) making sure the holes in the
rear hopper tube are facing up.
*
Secure the rear hopper tube (11) to the lower hopper
tubes (10) with two 1/4" x 1" curved head bolts (26)
and 1/4" nylock nuts (24).
NOTE: Hopper bag (3) not shown for clarity.
Hole must face up
11
FIGURE 8
Advertisement
