Installation Of Batteries; Turning The Power On And Off; Sound Quality; Adjusting The Volume - Hitachi AX-M131U Operating Instructions Manual

Installation of Batteries

1. Remove the battery compartment cover.
2. Insert two batteries (size AAA) correctly so that the + and - polarities match the polarity diagrams
in the battery compartment.
* About half a year of normal operation can be expected.
* When the batteries are exhausted, the remote control can no longer operate the system. Replace
both batteries at the same time with new ones.
* Don't use an old battery with a new one.
* Don't use different types of batteries together.
* When the remote control is not to be used for a long time period of time, remove the batteries to
avoid damage caused by battery leakage and corrosion.

Turning the Power On and Off

Turning the System On
Press the standby button (STANDBY) to turn the system on from standby mode. The display comes
on.
Caution: When turning the system on, the system comes on ready to continue in the mode it was
in when last turned off.
Turning the System Off
Press the standby button (STANDBY) again to turn the system off (called Standby Mode). The clock
will be displayed.
Caution: Be sure to unplug the system from the wall output when the system is not in use for an
extended period of time.

Sound Quality

Adjusting the Volume

To increase or decrease the volume, rotate the volume control knob (- VOLUME CONTROL +) on the
amplifier or press the volume up/down buttons (VOL +/-) on the remote control.
For private listening, you can connect headphones to the headphone jack, no sound comes out of
the speakers.
Note: Be sure to turn down the volume before connecting or putting on headphones.
Warning: The unit automatically turns on at volume 8.

Adjusting the super bass

You can reinforce the bass sound to maintain rich, full bass at low volume:
Press the super bass button (S-BASS) on the remote control to get the effect, the "BASS" will
display on the VFD. Press the button again to cancel the effect.

Control the Loudness

This unit has loudness function, it can automatically increase bass sound effect at low volume (the
higher volume, the smaller bass increase). You only need to press the loudness button (LOUDNESS)
to obtain the loudness function, the "LOUDNESS" will display on the VFD.
- 7 -