Data Block Verification Methods (Recommended) - Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications

Disk Media Management
6.3

Data Block Verification Methods (Recommended)

The recommended procedure for verifying from the INIT the normalcy of logical data blocks located on
the disk media is as shown below. It is desirable for the INIT to verify the data blocks after initialization
of the disk media is completed or when executing alternate block allocation processing by the
REASSIGN BLOCKS command.
Note:
The INIT must not recognize the defective data blocks included in the P List as normal data blocks in
the verification operation.
After the INIT has written a specific data pattern for logical data blocks which is the object of
verification using the procedure described below, it next reads those data or verifies the data blocks by
executing Verify.
(1) Setting parameters by the MODE SELECT command
Issue the MODE SELECT or the MODE SELECT EXTENDED command and prohibit retry processing,
data correction and operation of the Read-Ahead Cache feature. The necessary parameter settings are as
shown below.
a. Read/Write Error Recovery Parameters (Page 1)
•
AWRE = 0, ARRE = 0
•
TB = 0 or 1
•
EER = 0, PER = 1, DTE = 1, and DCR = 1
•
Number of Retries during Read = Zero
•
Number of Retries during Write = Zero
b. Verify Error Recovery Parameters (Page 1)
•
EER = 0, PER = 1, DTE = 1, and DCR = 1
•
Number of Retries during Verify = Zero
c. Caching Parameters (Page 8)
•
RCD = 1
(2) Writing a data pattern
Write a data pattern for verification in the data block which is the object. The recommended data pattern
at this time is X '0123456789ABCDEF' repeated. The WRITE, WRITE EXTENDED or WRITE SAME
command can be used to write data.
6-6 C141-C010