Electrolux ICON E30DD75ESS Brochure & Specs page 2

Downdraft Vent
E30DD75ESS
Side
Stiffener
5
1 / "x16"
8
exhaust duct
3 1 / " x10"
4
exhaust duct
Against-Wall
Downdraft
Installations
30" Downdraft Vent Specifications
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.0 kW
•
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Amps @ 120 Volts = 8.0 Amps
•
Do not use same circuit as cooktop.
•
Always consult local and national electric codes. Check local
•
building codes for installation requirements, as they may vary per locale.
1,600 CFM remote exhaust blower (PN # 5304444802) included
•
with vent – shipped in separate box.
Vent must be installed in vertical orientation only.
•
Vent unit outside of building only.
•
Exhaust Duct Required – 3-1/4" x 10" (3-1/4" x 10" to round transition
•
duct will be needed)
Do not use flexible duct. Round duct instead of rectangular duct
•
recommended, especially when elbows are required.
When multiple elbows are necessary, ensure a minimum of 24" of
•
straight duct between any two elbows.
Thermal breaks such as short section of nonmetallic duct, should
•
be used in areas of extreme cold.
Electrolux Major Appliances, N.A.
USA 250 Bobby Jones Expressway
• •
5855 Terry Fox Way Mississauga, ON L5V 3E4
CANADA
• •
E30DD75ESS 09/09
3 / "
8
Studwall
9 7 / "
16
Wallboard
18 13 / "
16
3"
1 15 / "
16
3 3 / "
4
3 / "
4
Finished Floor
Blower
3 1 /
Roof
to round
transition
Wallboard
Backsplash
Stud wall
3 1 / "x 10"duct
4
Vent unit
3 1 / "x 10"
4
Motor cover
90 elbow
Anchoring leg
Finished floor
Roof Exhaust
Augusta, GA 30907 1-877 -4electrolux (1-877 -435-3287)
•
1-800-265-8352
•
Front
3 / " max.
4
backsplash
thickness
1 / " min.
4
1
2 / " 25
8
30"
Cooktop/
Range
3 1 / " x 10"
4
rear exhaust
9 / "
duct
32
2 13 / "
16
Anchoring legs
1 5 / "x 16" exhaust duct
8
Cap Profile
1 3 / "
16
2 1 / "
2
" x 10"
4
Backsplash
Cooktop
Outside wall
3 1 / "x 10"duct
4
90 elbow
Anchoring leg
For most efficient airflow exhaust, use a straight run or as few elbows
•
as possible.
Cold weather installations should have additional backdraft
•
damper installed.
Installing a Downdraft Vent in combination with any gas cooking surface
•
will affect optimum burner efficiency.
Downdraft Vents can NOT be used in combination with any cooktop
•
backsplash.
Downdraft Vent model E30DD75ESS is approved to be used in
•
combination with Electrolux ICON
E30EC65ESS, E30EC70FSS, E30IC75FSS, E30IC80ISS, E30GC64ESS,
E30GC70FSS;
and Electrolux ICON
(For detailed countertop preparation, refer to Drop-In and Slide-In
Cooktop / Downdraft Vent Countertop Preparation pages on web.)
Proper combination installation of Electrolux ICON
•
E30DD75ESS and approved 30" Gas Slide-In Cooktop will require
cooktop power cord to be relocated to underside of unit. (For details,
refer to 30" & 36" Gas Slide-In Cooktop Power Cord Relocation
Instructions on web.)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
electroluxicon.com
•
electroluxicon.ca
•
© 2009 Electrolux Home Products, Inc.
30"
10"
27 3 / "
4
Countertop
7
/ "
8 1 5 / " x 16"
8
exhaust ducts
Motor cover
48", 3-prong,
6"
grounded
power cord
Finished
8 1 / "
2
Floor
Electrical access panel
Specifications
For Use With Duct Size
30" Cooktops 3 1 / " x 10"
4
Stud wall
Wallboard
Cooktop
Blower
Vent unit
3 1 / "x 10"
4
Motor cover
Finished floor
Exterior Wall Exhaust
® Drop-In Cooktop models
® Slide-In Cooktop model E30GC74GPS.
® Downdraft Vent model
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
Printed in the U.S.A.