Bosch TDA5610GB Operating Instructions

Solving Minor Problems Yourself
Problem Possible Causes Solution
Temperature control (H) set Turn the temperature control
to minimum to the desired position
Iron does not
Connection problems Check that the plug is inserted
work or is not
into the mains socket correctly
heating up
The automatic shut-off Move the iron gently from side
system has been activated (*) to side to re-start it
There is no water in the tank Fill the water tank
(D)
Iron is not
steaming
The steam regulator (A) is in Set the steam regulator to the
the position relevant position
Temperature control (H) Set the temperature control
setting is too low. within the steam area
(between the "••" and "max")
or turn the steam regulator (A)
to
Steam regulator (A) is set Turn the steam regulator to a
too high in conjunction with lower setting.
a low temperature.
You have pressed the Wait 5 seconds between
shot of steam button (L) each press of the jet of steam
Water is
repeatedly without waiting
button
dripping from
for 5 seconds between each
the holes in
press
the soleplate
Water has been left in the Always empty the tank after
tank (D) when the sole plate ironing and set the steam
was cold, with the steam regulator to
regulator (A) set at or and when filling the tank
Distilled water has not been Mix distilled water with tap
used (see "Filling the water water as directed in the "Filling
tank" section) or other the water tank" section and
products such as fragrant never add any other products
water have been added to to the water tank
the tank
No water in the tank. Add water to the water tank.
Spray does
Obstructed mechanism. Contact an Authorised
not work.
Technical Service Centre.
During first use: Certain This is completely normal and
The iron components on the will stop after a short while.
begins to appliance have been lightly
smoke when greased at the factory and
switched on. may produce a little smoke
when initially heated.
Deposits Traces of lime scale are Carry out a cleaning cycle (see
come out
coming out of the steam "self cleaning" section)
through the chamber
holes in the
soleplate
Auto-shut off has been Move the iron gently fromside
Flashing
activated. to side to re-start it. The lamp
lamp on top
will then flash once before it
of handle (*)
re-heats
* Model dependent
You can download this manual from the local homepages of Bosch
Thank you for buying the TDA56 steam iron from Bosch. These
instructions contain valuable information about the unique features
of this iron and some hints to make ironing easier for you.
Please visit www.bosch-home.co.uk for more product
information or to register your product, just follow the
link to the Online guarantee registration.
Important
This appliance has been designed exclusively for domestic
use and must not be used for industrial purposes.
Carefully read through the operating instructions for the
appliance and safeguard them for future reference.

General safety instructions

• The iron must not be left unattended while it is
connected to the supply mains.
• Remove the plug from the socket before filling the
appliance with water or before pouring out the
remaining water after use.
• The appliance must be used and placed on a stable
surface.
• When placed on its stand, make sure that the surface
on which the stand is placed is stable.
• The iron should not be used if it has been dropped,
if there are visible signs of damage or if it is leaking
water. It must be checked by an authorized Technical
Service Centre before it can be used again.
• With the aim of avoiding dangerous situations, any
work or repair that the appliance may need, e.g.
replacing a faulty mains cable, must only be carried
out by qualified personnel from an Authorised
Technical Service Centre.
• This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without
supervision.
• Keep the iron and its cord out of reach of children less
than 8 years of age when it is energized or cooling down.
•
CAUTION. Hot surface.
Surface is liable to get hot during use.
after ironing
• This appliance is to be connected and used in accordance with
the information stated on its characteristics plate.
• This appliance must be connected to an earthed socket. If it is
absolutely necessary to use an extension cable, make sure that
it is suitable for 16A and has a socket with an earth connection.
• If the safety fuse fitted in the appliance blows, the appliance
will be rendered inoperative. To restore normal operation the
appliance will have to be taken to an authorised Technical
Service Centre.
• In order to avoid that, under unfavourable mains conditions,
phenomena like transient voltage drops or lighting fluctuations
can happen, it is recommended that the iron is connected to a
power supply system with a maximum impedance of 0.27Ω . If
necessary, the user can ask the public power supply company
for the system impedance at the interface point.
• The appliance must never be placed directly under the tap to
fill the water tank.
• Unplug the appliance from the mains supply after each use, or
if a fault is suspected.
• The electrical plug must not be removed from the socket by
pulling the cable.
• Never immerse the iron in water or any other fluid.
• Do not leave the appliance exposed to weather conditions (rain,
sun, frost, etc.).
Tips to help you save energy
Steam production consumes the most energy. To help minimise
the energy used, follow the advice below:
• Start by ironing the fabrics that require the lowest ironing
temperature.
• Regulate the steam according to the selected ironing
temperature.
• Only use steam if necessary. If possible, use the spray function
instead.
• Try to Iron the fabrics while they are still damp and reduce the
steam setting. Steam will be generated from the fabrics rather
than the iron. If you tumble dry your fabrics before ironing them,
set the tumble drier to the 'iron dry' programme.
• If the fabrics are damp enough, turn off the steam regulator
completely.
• Stand the iron upright during pauses. Resting it horizontally
with the steam regulator on generates wasted steam.
Customer Service
Great Britain
Bosch Customer Service
Grand Union House
Old Wolverton Road
Milton Keynes
MK12 5PT
UK +44 (0)844 892 8923
IRL +353 (0)1450 2655
www.bosch-home.co.uk
006 TDA56..GB/09/12
TDA56..
sensixx B4
Operating instructions
GUARANTEE TERMS
The terms of the guarantee for this appliance are in accordance
with that stated by our representative for the country in which
it is sold. Details of those conditions can be obtained from the
retailer from whom the appliance was purchased. The SALES
RECEIPT must be presented when making any claims against the
terms of this guarantee. We reserve the right to make technical
modifications.
Environmental Care
This iron has been redesigned according to ecological criteria,
related to the sustainable development, analyzing its whole
lifecycle - from material selection to its later reusing or recycling
- evaluating the improvement possibilities, from a technical,
economical and environmental point of view.
Before throwing a used appliance away, you should make it
noticeably inoperable e.g. cut off the mains lead and be certain
to dispose of it in accordance with current laws and regulations.
Your retailer, town council or local council can give you detailed
information about these.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste
electrical and electronic equipment - WEEE).
The guideline determines the framework for the
return and re cycling of used appliances as applicable
throughout the EU.
Before using the Iron for the first time
Please carry out the following steps:
1. Remove the protective cover from the soleplate before using
the iron.
2. While the iron is unplugged, fill the water tank (D) with tap water
3. Plug the appliance into the mains and set the temperature
control (H) to the "•••" position by lining it up with the pointer
(G) on the iron.
4. When the iron has reached the correct temperature (the
pilot lamp "I" will goes out), set the steam regulator (A) to the
maximum position .
5. Hold the iron horizontally and repeatedly press the shot of steam
button (L). Any residue should come out of the soleplate (E).
It may smoke and smell – this is normal and will cease after a
short while.
6. If necessary, carefully clean the soleplate down with a dry, folded
cloth.