Managing Hardware Setup
Saving Your Settings
When you have configured all your settings, follow these steps:
Click Apply to register new or modified settings.
Step 1
Click Reset to restore the original settings.
Step 2
Attaching the Camera Hood Assembly
After you complete the camera adjustment, attach the camera hood assembly. See
Note
Attach the top hood before attaching the bottom hood.
Do not overtighten the screws, or use a power screwdriver to tighten the screws. In addition, make sure
Caution
that you use screws of the correct length (20 mm). Overtightening the screws, or using a screw that is
too long, can cause the plastic hoods to break.
Cisco TelePresence System Release 1.6 Administration Guide
8-12
Chapter 8
Troubleshooting the CTS 3000 and CTS 3200
Figure
8-6.
OL-13676-05