Installing The Netserver - HP D7171A - NetServer - LPr Installation Manual

Rail Flange
Figure 3-4. Mounting a Rail To a Column

Installing the NetServer

WARNING To prevent the rack from tipping over, be sure that the
stabilizing, anti-tip feature is installed on this rack enclosure
(see Figure 1-2).
1. Remove the hot-swap disk modules from the NetServer before lifting it into
the rack enclosure.
WARNING Use two people when moving the NetServer or lifting it into
the rack.
2. Using two people, lift the NetServer and move the NetServer in between
the rails. Slide it all the way back until the mounting tabs on either side of
the NetServer front panel rest against the equipment rack columns (see
Figure 3-5).
Front Column
Installation
Rack
Nuts
11