Chapter 3
2. Install the four screws that hold the tall, left-hand bracket to the face of the
NetServer chassis and to the rack column see Figure 3-10.
3. Install the four screws that hold the short, right-hand bracket to the face of
the NetServer chassis and to the rack column see Figure 3-10.
Figure 3-10. Installing the Recessed Mounting Brackets
Relocating the Control Panel
The control panel and the control panel bezel must be relocated to fit the Compaq
rack-compatible NetServer bezel. Relocate the control panel and its bezel, as
follows:
1. Remove the control panel bezel from the NetServer by pressing in on the
clips on either side of the bezel.
2. Unscrew the two screws securing the control panel to the chassis.
3. Unhook the control panel from the face of the chassis see Figure 3-11. A
ribbon cable still connects it to the NetServer.
Installation
Recessed Brackets
19