Assigning Container Properties - HP D7171A - NetServer - LPr Installation Manual

If you install an adapter into a system that has been powered down,
on startup the BIOS will announce the detected configuration
changes. If the system considers these changes to be non-risk, the
system will present a confirmation prompt (and will auto-confirm if
there has been no operator input in 30 seconds. If the system
considers the changes to be risky, the user will be prompted for
further action.

Assigning Container Properties

Follow these steps to assign various properties to the new container.
Note:
You cannot change these properties from the CCU
once the container is created; you must instead use the GUI
or the CLI.
1
In the Container Properties menu, select a container type and
press Enter. Only container types available according to the
number of disks selected displays. Your possible options are
– Volume: A container made up of one or more partitions,
linked together.
– RAID 0 (Stripe): Data is striped across the partitions in a
RAID 0 container, allowing for faster I/O performance than
a single disk or volume. If one drive fails in a RAID 0
container, the container is marked Dead.
Note:
Volume and RAID 0 containers do not store
redundant data; if any disk in the container fails, all
data is lost.
– RAID 1 (Mirror): Data is mirrored on two equal-sized
partitions that reside on two different disks. If one disk fails,
data is available from the other disk. The actual data
capacity of the container equals half the available disk
space.
– RAID 5: The container contains redundant (parity) data
distributed across all partitions in the container. If any one
disk fails, the container is marked Critical, and data can be
reconstructed from the parity information. If a second disk
Using the BIOS Container Configuration Utility
B-3