Step 3: Connect The Drive - HP D6030A - NetServer - E50 Installation Manual

Chapter 3
Align the four screw holes in the bottom of the NetServer E 45 tray with
the four screw holes in the bottom of the drive.
Loosely install all of the screws, then tighten the screws to no more than
eight inch-pounds (0.9 Newton-meter).
Place the tray in the shelf opening and slide the tray into the shelf.
Align the screw holes at the front of the tray with the holes in the front of
the chassis.
Loosely install all screws, then tighten each screw to no more than eight
inch-pounds (0.9 Newton-meter).

Step 3: Connect the Drive

Connect the SCSI data cable and power cable and complete the drive installation.
The SCSI cable is connected to the SCSI connector on the SCSI host bus adapter
board. (If you are using a narrow 50-pin cable (part number 5182-4551) when
connecting to a HP NetServer E45, a 68-50 pin adapter will also be needed.)
The correct cable for the E 45 or E50 must have an active termination module on
one end of the cable. The active termination module is easy to recognize, because
it looks different from the other connectors on the cable. The cable bundled with
your system is actively terminated, and is singled ended.
NOTE
HP Ultra3 SCSI drives must connect to the actively terminated
cable. Using an incorrect cable (or not using an active
termination module) will cause data transmission errors. Do
not use passively terminated cables with Ultra3 SCSI hard
disk drives.
CAUTION The active termination module belongs on the last connector
on the cable. Do not remove this terminator.
Connect the internal power supply cable to the hard disk drive with one of
the unused cables from the power supply unit.
Select an available connector on the SCSI cable and connect it to the disk
drive.
CAUTION The connector is keyed. Do not force the connector in the
slot. (The red stripe on the edge of the cable denotes the
position of Pin 1 on the cable.)
20
Mount the Drive in the NetServer E 45 or E 50