Hp Xw8000 And Hp Xw9000 Computers; Step 3-Installing A Hard Disk In The Dx115 Carrier - HP Z220 Installation Manual

HP xw8000 and HP xw9000 computers

1. Remove the front bezel from the computer. See
2.
Remove and discard the counter-sunk shipping screw at the side of the DX115 case. See
Removing the shipping screw on page
3. Lift and hold the drive release latch at the touch point (1) while sliding the DX115 case into the
bay (2). When the front of the drive is near its final position, release the latch, but continue to slide
the drive inward until the latch closes and engages the drive.
Figure 22
4.
Install the M3 x 5mm screw (black) for each DX115 unit for shipping support. Spare M3 screws
supplied with your workstation are mounted on its chassis.
CAUTION:
drive system.
Figure 23
Step 3—Installing a hard disk in the DX115 carrier
Some product options may require you to install a hard drive in the DX115 carrier. For additional
information, see:
The CRU Dataport DX115 User's Guide for SATA or SAS removable drive enclosures
●
The CRU Dataport website at
●
dx115.html
14 CRU Dataport DX115 kit installation
Installing the DX115 case
Failure to install the shipping screw might result in damage to the removable hard
Installing the shipping support screw
http://www.cru-dataport.com/htmldocs/products/dataexpress/
Figure 14 Removing the front bezel on page
7.
9.
Figure 8
ENWW