7.
Choose from the following:
●
For a single SATA drive, connect the SATA 0 data cable from the hard drive to the SATA0
port in the workstation chassis, as shown in the following figure.
●
For a second SATA drive, connect the SATA 1 data cable from the hard drive to the SATA1
port in the workstation chassis.
Figure 4-53
To install three or four SATA drives, install the third and fourth drives in the workstation optical bays.
For instructions, see
Installing SATA hard drives in an optical drive bay (optional)
1.
Disconnect power from the system (see
2.
Remove the side access panel (see
3.
Remove the front bezel (see
4.
If necessary, remove the EMI shield from the optical bay in which it will be installed.
94
Chapter 4 Removal and replacement procedures
Connecting the SATA data cable to the workstation SATA port
Installing SATA hard drives in an optical drive bay (optional) on page
Removing the front bezel on page
Predisassembly procedures on page
Side access panel on page
94.
52).
58).
61).
ENWW