Adpt160M.ham Command Line Options - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

Chapter 5

adpt160m.ham Command Line Options

Table 5-1. adpt160m.ham Command Line Options
Option
auto_disable_tagq=
dev_enable=
flush_diskreq=
instr=
1
lun_enable=
max_tags=
48
Values Default
on, off off
0-FFFF FFFF
0-FFFF 0
on, off off
0-FF 01
1-128 16
Novell NetWare Installation
Description
Enables/disables auto disable
tagged queuing algorithm.
Allows you to enable the driver's
registration of SCSI devices on a
per target basis. By default, all
targets are scanned. A bit value
of 0 causes the target not to
register under the operating
system. These devices are still
accessible via ASPI. This enable
bit mask is entered in hex (see
"Bit Mask Options" on
page 49).
A bit mask to send occasionally
ordered tags to specific targets.
By default, no targets receive
occasionally ordered tags. This
bit mask is entered in hex (see
"Bit Mask Options" on
page 49).
Enables/disables recording of I/
O statistics.
A bit mask to enable scanning
for specific LUNs on all targets.
The default value of 01 causes
the driver to scan LUN 0 only.
This enable bit mask is entered
in hex (see "Bit Mask Options"
on page 49.)
Specifies maximum number of
tagged commands per device.