Rear Terminal
①
②
R/C jACK
①
When using the wired remote control, connect
the wired remote control to this jack with a remote
control cable (not supplied).
USB
②
In order to operate the computer with the remote
control and use the PAGE
remote control during a presentation, connect the
USB port of the computer to the USB terminal with
a USB cable (not supplied) (pp.13, 19).
SERVICE PORT
③
This jack is used to service the projector.
COMPUTER IN /COMPONENT IN
④
Connect the computer or component video (or RGB
Scart) output signal to this terminal (pp.19, 21).
Use the supplied VGA cable or a Component-VGA
cable commercially available.
MONITOR OUT
⑤
This terminal can be used to output the incoming
RGB analog signal from COMPUTER IN 1 and
COMPUTER IN 2/COMPONENT IN terminal to the
other monitor (p.19).
COMPUTER IN 1/DVI-I
⑥
Connect computer output (Digital/Analog DVI-I
type) to this terminal (p.19).
LAN Connection Terminal
⑦
Connect the LAN cable (Refer to the owner's
manual of "Network Set-up and Operation".).
③
④
⑧
buttons on the
▲▼
Part Names and Functions
⑤
⑥
⑨
⑩
⑪
⑫
VIDEO IN
⑧
Connect the composite video output signal to this
jack (p.20).
AUDIO IN
⑨
Connect the audio output signal from video
equipment connected to
mono audio signal (a single audio jack), connect it
to the L (MONO) jack (p.20).
COMPUTER/COMPONENT AUDIO IN
⑩
Connect the audio output (stereo) signal from a
computer or video equipment connected to
to this jack (pp.19, 21).
AUDIO OUT (VARIABLE)
⑪
Connect an external audio amplifier to this jack
(pp.19–21).
This terminal outputs sound from AUDIO IN terminal
(
or
).
⑨
⑩
S-VIDEO IN
⑫
Connect the S-VIDEO output signal from video
equipment to this jack (p.20).
SD Card Indicator
⑬
Display the status of SD card.When inserting SD
Card, the indicator lights, and when removing SD
Card, the indicator turns off.
SD Card Slot
⑭
Insert the SD card memory (not supplied) for
Memory viewer operation.
⑦
SD
⑬
⑭
or
to this jack. For a
⑧
⑫
or
④
⑥
11