HP A3550A - High Availability Disk Arrays Model 20 Storage Enclosure User Manual page 301

Table 6-12 Extended Status Codes (Continued)
Extended Extended status code
status code name
0x3E Media error remap failed
0x3F Media error bad defect list
0x7E Extended media error
0x80 CRU Powered Down
0x81 CRU Powered Up Dead
0x82 CRU Defined Powered
Down
0x83 CRU Defined Dead
0x84 CRU Too Small
0x85 CRU Unsupported
0x86 CRU Format Failed
0x87 CRU Idle Powered Down
0x88 CRU Idle Dead
0x89 CRU Bind Powered Down
0x8A CRU Bind Dead
0x8B CRU Wait for Assign
Powered Down
0x8C Shutdown
0x8D CRU Rebuild Powered
Down
0x8E CRU Rebuild Dead
0x8F CRU Enabled Powered
Down
0x90 CRU Enabled Dead
Description
An attempt to do a remap after a Media error failed for some
reason other than one of the following: another media error, a
timeout, cannot remap (no LBA provided), or bad defect list.
All of these errors are itemized separately.
Device returned a Media Error check condition which
specifically indicates that the device's "defect list" is no good
(03/19) or (03/1c). A remap is not possible for these errors.
A remap of a bad block failed. Usually seen with event codes
0x820 or 0x920.
During a sniff, the device was found to be powered down.
While powering up a CRU died.
Switched from defined state to powered down
Drive found dead while in defined state.
Drive is too small to fit in the assigned LUN.
Drive is not supported and has been shutdown.
The format of the drive aborted for some reason. Further
information may be provided in other Unsolicited Event Log
messages.
CRU was found to have powered down while idle.
CRU died while in idle state.
The drive powered down while unbound.
CRU died while unbound.
CRU powered down while in the RDY state.
Shutdown while waiting to assign a LUN. Usually seen with
event code 0xA07. CRU died in RDY state.
CRU powered down during a rebuild.
CRU died during a rebuild.
CRU powered down in ENA state.
CRU died in ENA state.
Unsolicited Event Log 6-53