Setting Your System (Calibration); Starting The Elite Panaboard Software And Performing Calibration - Panasonic UB-T880W Operating Instructions Manual

Setting Your System
.
(Calibration)
About Calibration
Calibration refers to setting up the elite Panaboard and
projector so that lines and comments drawn with your
finger or the electronic pen are displayed in the correct
position. Be sure to perform calibration before use.
After you have set up the elite Panaboard, project an
image onto the screen board and use the elite
Panaboard software installed on your computer to
perform calibration.
After Calibration
Do Not Move the elite Panaboard or the
Projector
•
The following changes will bring the position of
projection out of alignment with the position of your
finger or the electronic pen, and you will need to
recalibrate the equipment.
– The location of the projector changed.
– The location of the elite Panaboard changed.
– The image area or placement was changed due
to changes in the zoom, focus, etc.
– The resolution of the projector or the computer
changed.
•
If you are using the elite Panaboard installed on a
stand, be aware that accidentally hitting the elite
Panaboard or pushing too strongly with the
electronic pen while operating can move the stand's
position, which will result in misalignment of the
projected image and the electronic pen's position.
•
Make sure to lock the stand's casters when using the
elite Panaboard, as failing to do so can cause
misalignment.
Note
•
To perform calibration, click the
notification area and click [Calibration] in the
pop-up menu.
Starting the elite
Panaboard software and
Performing Calibration
1.
Turn on the elite Panaboard.
2.
Connect the elite Panaboard to your computer
with the USB cable.
•
The elite Panaboard software starts
automatically.
•
Once the elite Panaboard software starts up, the
calibration screen is automatically displayed.
•
Restart your computer if you are prompted to do
so. After the computer has restarted, connect the
elite Panaboard to your computer with the USB
cable.
3.
Calibrate the equipment by using your finger to
touch the center of the indicated points in the
order shown for about 2 seconds.
•
Touch the screen board at a right angle with your
finger.
•
After you touch an indicated point correctly, the
next point is shown automatically.
icon in the •
When calibration has finished normally, a
completion dialog box is displayed.
Usage
Operating Instructions 25
1