30
en | Quick Installation
4
Quick Installation
This chapter describes how to put the device into operation quickly and easily.
Main connections
1.
2.
3.
4.
Optional connections
The optional connections can be added after the system is configured.
1.
2.
3.
4.
5.
Switching on
1.
2.
3.
First-time use
Once the boot routine is complete, 1 image/second is stored for every camera connected.
The user interface is automatically displayed. This shows images from all connected cameras
in a multi-image view. If no images are displayed for a camera, check the camera connection.
You are not yet logged on as a user. You can, however, start the Configuration wizard.
Quick configuration with the help of the Configuration wizard
1.
2.
F.01U.033.308 | V7 | 2009.09
Connect the cameras to the video inputs.
Make sure that the HW dongle is connected to the parallel interface (if you are handling a
device that has been supplied with a HW dongle).
Connect the VGA monitor.
Connect the mouse and keyboard.
Connect monitor A and monitor B to connections A and B.
Connect up to 32 alarm inputs (for DiBos micro: 12).
Connect up to 16 relay outputs (for DiBos micro: 12).
Connect your network via the Ethernet port.
Connect customer-operated ATMs, foyer card reader, radio clock and alarm panel.
Switch on all connected devices.
Plug the power cable into the video system.
Switch on the video system (On/Off switch on the front). The computer boots up.
Start the Configuration wizard in the System menu > Configuration wizard.
Carry out a quick configuration in the Configuration wizard or load an existing
configuration onto the system.
Installation Guide
DiBos/DiBos Micro
Bosch Sicherheitssysteme GmbH