Direct Attach Method; Procedure - HP 345646-001 - StorageWorks NAS 2000s External Storage Server Installation Manual

Direct Attach Method

You can access the WebUI using a monitor, mouse, and keyboard
directly attached to the NAS 2000s.

Procedure

To initialize the NAS 2000s:
1. Connect the Ethernet cables to the respective network ports
of the NAS 2000s and the corresponding network segments.
2. Connect the monitor, mouse, and keyboard directly to the rear
panel connectors of the NAS 2000s. See
on page 14 for the locations of the connectors on the NAS
2000s.
3. Open Internet Explorer and click Yes in the Security Alert
dialog to accept the security certificate. This launches the
WebUI configuration application (Rapid Startup) on the
target StorageWorks NAS device, as shown in
WebUI does not launch connect to the LocalHost and login to
the WebUI.
Note:
password is hpinvent. The WebUI uses the same login as the local
administrator's account or an account with administrative privileges.
4. Go to the
to complete the setup procedures.
26
The default login for the WebUI is administrator and the
"Rapid Startup Wizard
Figure 3
Figure
Configuration" on page 27
NAS 2000s Installation Guide
and Table 2
7. If the