HOW TO REPLACE THE BELT
When replacing the belt, always set
the RUG/FLOOR Selector to the
"FLOOR" position.
After removing the bottom plate
1
(see page 13), lift up the belt
cover and remove the pulley cover
to determine if the belt is worn or
broken. (Fig. 38)
Pulley cover
2
Pull out the agitator and then remove the flat belt
from the motor shaft. (Fig. 39)
3
Loop the new belt around the motor shaft and
agitator as shown. (Fig. 40)
4
Then re-insert the agitator assembly, making
sure that both ends of the agitator assembly fit in
the groove of the nozzle head. (Fig. 41)
Be sure to install the new flat belt into the guide
properly.
5
Be sure that the flat belt is not twisted and all
rotating parts move smoothly. (Fig. 42)
After reinstalling the pulley cover, close the belt
cover and replace the bottom plate.
REPLACEMENT INSTRUCTIONS
(CT1500 type)
Flat belt
Idler pulley
Main pulley
Agitator assembly
Flat belt
Main pulley
Idling pulley
New belt
Motor shaft
Groove
Belt cover
Pulley cover
Belt cover
Motor shaft
Belt change
guide
Fig.38
Fig.39
Fig.40
Groove
Agitator
assembly
Fig.41
Fig.42
15