7. Loosen the thumbscrew on the sheet-metal cover nearest the left
Figure 2-27
Rotating the Sheet-Metal Cover
8. If the library is rackmounted, use the following steps to slide it
CAUTION
For library models 12/140, do not push the library out of the cabinet.
Instead, remove the side panels by using the procedure in "Accessing the
Side Panels for Service" on page 2-36.
WARNING
Failure to extend the anti-tip device could result in personal
injury or damage to the tape autoloader if the rack tips over.
Chapter 2
drive bay and rotate the cover clockwise (Figure 2-27).
forward in the rack (for models 2/20, 4/40, and 6/60 only):
a. Lower the leveler feet, and fully extend the anti-tip foot at the
front of the rack.
Removing and Replacing Major Library Components
Removing and Replacing the Motherboard
2-53