Installing Optional Equipment
4.
Disconnect the two FDD cables ("FDD CN5" and power "CN5") from the main circuit
board.
• The FDD flat cable is held in place by a cable strap. Remove the cable from the cable strap before instal-
lation.
5.
Remove the four gold-colored screws with which the FDD is attached, and slide the
FDD backward (toward the rear panel) to remove it.
6.
Turn the FDD unit over, and remove the mount panel from the drive by removing the four
gold-colored screws.
7.
Attach the ZIP drive to the mount panel using the screws removed in step 6.
• Do not use screws other than those removed in step 6. Other screws can damage the ZIP drive.
248
Appendix
• A5000/A4000
A
ZIP Drive
B
A
FDD unit
Tighten in the following order:
q
w
FDD Mount Panel
e