n
/Rx — Reboot system after configuration
x
0 = System port reboot
1 = Far jmp F000:FFF0h (hard reset address)
For example, the following command line disables the SCSI
port:
device=c:\ds4000\scsictrl.sys /S0
The following example disables the SCSI port and then re-
boots the system using the system port:
device=c:\ds4000\scsictrl.sys /S0 /R0
The next example enables the SCSI port and specifies an
alternate IRQ:
device=c:\ds4000\scsictrl.sys /S1 /Q4
Do not use a drive connected to this port as
the boot drive for your operating system. Due to the
system configuration routine, booting from this port
usually fails.
Setting Up and Using the Software 3-21