The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
show arpentry
config arp_aging time
clear arptable
Each command is listed, in detail, in the following sections.
show arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To display the ARP table:
DES-30XX Layer 2 Switch CLI Reference Manual
Parameters
{ipif <ipif_name 12> | ipaddress <ipaddr> | static}
<value 0-65535>
Used to display the ARP table.
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> |
[static]
This command is used to display the current contents of the
Switch's ARP table.
<ipif_name 12> − The name of the IP interface the end node or
station for which the ARP table entry was made, resides on.
<ipaddr> − The network address corresponding to the IP interface
name above.
static − Displays the static entries to the ARP table.
None.
152
25
ARP C
OMMANDS