Table of Contents
Advertisement
Command Line Interface
The DG-102SP VoIP Gateway offers a line-at-a-time prompt and response
scheme to execute various configuration instructions. The interface displays a
single prompt character ggdbg> when it is ready to accept a command (ex.
ggdbg>set or ggdbg>show).
Typing a question mark after the ggdbg> prompt will display a list of helpful
user commands. Please note that all characters must be entered in lower case.
All command line examples in this chapter are in bold type.
Listed below are some of the most commonly used commands, parameter(s),
and examples of their usage.
General Setup Commands
nwdbg system reboot
Definition:
Parameter(s):
Example:
nwdbg save changes
Definition:
Parameter(s):
Example:
nwdbg factory reset
Definition:
Parameter(s):
Example:
This command is used to restart the device.
None.
nwdbg system reboot
This command is used to save the configuration changes
into flash memory and restart the device.
None.
nwdbg save changes
This command is used to set the DG-102SP back to its
default settings and then restart the device.
None.
nwdbg factory reset
56
Advertisement
Table of Contents
