Table of Contents
Advertisement
DFL-M510
IP Address
Subnet Mask
Default Gateway
1. Connect one end of the RS-232 cable to the console port on the DFL-M510 and the other end
to the COM1 or COM2 port on the PC. (The pin out definitions are shown below.)
Terminal Emulation
Bit per Second
Data Bits
Parity
Stop Bits
Flow Control
2. To open a connection in Windows 95/98/NT/2000/XP go to, Program Files
Communications
3. Once you access the Command Line Interface (CLI) with a terminal connection, press any
key. The following prompt appears:
4 -- Chapter 1: Getting Started with the DFL-M510
192.168.62.100
255.255.255.0
192.168.62.1
VT-100, ANSI, ot auto
115200
8
None
1
Nine
Super Terminal.
Accessory
Advertisement
Table of Contents
