DURING INSTALLATION
•
Do not place the cable terminal in an
enclosed area where the cooling vents are
blocked or impede the flow of air through
the ventilation openings.
•
Install the terminal so that its position does
not interfere with its proper ventilation. For
example, do not place the terminal on a bed,
sofa, rug, or similar surface that could block
the ventilation openings.
•
Install the terminal away from heat sources
such as radiators, heat registers, and stoves.
Installation of the terminal near consumer
iv
electronics devices, such as stereo
receiver/amplifiers and televisions, is
permitted as long as the air surrounding the
terminal does not exceed 40º C (104º F).
•
Place the terminal on a flat surface not
prone to vibration or impact.
•
Do not install the terminal in an area
where condensation occurs.
•
To prevent the temporary loss of guide
data and cause a temporarily non-
responding terminal, do not plug the AC
power cord into a switched power outlet.
FCC COMPLIANCE
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a