D-Link DWL-810 Owner's Manual page 15

Web Configuration
Transmission Rate: Automatic is the default setting. Choose the
the transmission rate of the DWL-810 from the pull-down menu.
Access Point Density:
Points and the traffic level of the wireless network running on Infrastructure
Mode, which is determined by the number of Access Points in your wireless
network and the configuration of the Access Points.
menu to choose from the 3 options: Low, Medium, or High.
WEP Enabled: The default setting is Disable. Wireless network
communications are easily intercepted. WEP (Wired Equivalent Privacy) is
an encryption method specified by the 802.11b standard to make any
intercepted communications extremely difficult to interpret by unauthorized
parties. All devices on the network, and the Access Point, must share the
same WEP selection – either Enable or Disable
To enable WEP Encryption, click on WEP Enable.
WEP Key Length: The default Key Length is 64-bit.
The WEP key is generated from Hexadecimal entries that are either 64 or
128-bit in length. When enabling encryption, select the Key Length, either
64 or 128-bit, and then input the Hexadecimal digits. You can create up to 4
keys.
Hexadecimal digits consist of the numbers 0-9 and the letters A-F
A 64-bit WEP key requires 10 Hexadecimal digits.
A 128-bit WEP key requires 26 Hexadecimal digits.
WEP Key to Use: Use the pull-down menu to select the WEP key. All
devices on the network must use the same key to communicate with one
another. Please be careful when entering WEP values, any input error
will result in a communication failure.
Deny Unencrypted Data: By default, this item is not selected. For
additional security when WEP is enabled, select Deny Unencrypted Data.
Data received without a WEP key is rejected when Deny Unencrypted Data
is selected.
This field describes the density of the Access
15
Use the pull-down