READ BEFORE INSTALLING UNIT For SLO3 Air Conditoner (8K~12K BTU) To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may be exposed: Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit.
Remove and dispose of / recycle packaging materials. Remove tape and glue residue from surfaces before installing the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
Page 3
Be sure your air conditioner cabinet does not fall out of the opening during installation or removal. The place where the power cord exits the air conditoner should be no more than 4 ft (122 cm) from a grounded 3 prong outlet.
Page 4
1. Extend the side curtains out against the window frame (FIG.11). 2. Drill holes and drive locking screws: A: For wooden windows: screws through the holes in the side curtains into the window B: For Vinyl-Clad windows: screw screw 3. Trim the weather seal...
Through-the-Wall Cabinet Installation: Option 1—wood, metal or plastic molding: When using a wood, metal or plastic molding, the wood frame should line up with the inside wall as shown FIG.18. Option 2—Plastered wall with no molding: into the inside wall FIG.19.
Page 6
2. Use a level to check that cabinet is level side to side (FIG.23). 3. Check that air conditioner cabinet is tilted to the outside so that water could run to the outside. The cabinet should slop at least half-a-bubble towards the rear.