Sealey WORKSAFE SSP66 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS &
CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR
FUTURE USE.
1. INTRODUCTION
Conforms to CE standards - BS EN 166/F. Modern, lightweight wraparound design, with flexible TPR arms, offers added protection and
increased user comfort. Polycarbonate anti-scratch lens.
MODEL NO. DESCRIPTION
SSP66 Safety Spectacles - Clear Lens
SSP67 Safety Spectacles - Anti-Glare Lens
SSP68 Safety Spectacles with EVA Foam Lining - Clear Lens
SSP69 Safety Spectacles with EVA Foam Lining - Anti-Glare Lens
Notified Body: 2797
Type Examination Certificate number: CE 712096
Carried out by: BSI Group The Netherlands B.V
2. SAFETY
WARNING! Safety glasses with polycarbonate lenses are impact resistant but may break under severe impact.
‰
WARNING! Eye protection worn over standard ophthalmic spectacles may transmit impact, thus creating a hazard to the wearer.
‰
WARNING! Materials which may come into contact with the wearer's skin could cause allergic reactions to susceptible individuals.
‰
WARNING! Scratched or damaged oculars should be replaced.
‰
Always perform a risk assessment and follow correct health and safety procedures before using this product.
9
DO NOT use tinted or clear lenses when welding or performing other operations which expose your eyes to harmful levels of radiation.
8
IMPORTANT: if protection against high speed particles at extremes of temperature is required, then the selected eye-protector should
be marked with the letter 'T' immediately after the impact letter, i.e. FT, BT or AT. If the impact letter is not followed by the letter 'T' then
the eye protector shall only be used against high speed particles at room temperature.
3. APPLICATIONS
3.1. EN 166 CATEGORISATION
• Optical Class 1 - suitable for work with high vision requirements for permanent use.
3.2. MECHANICAL STRENGTH
• FT - High speed particle at extremes of temperature - low energy impact
3.3. LENS MARKINGS
• SSP66 & SSP68 - 2C-1.2EV1FT - Clear lens
• SSP67 & SSP69 - 5-3.1EV1FT - Smoke lens
3.4. SUITABILITY
When worn tightly to the face, these safety goggles provide excellent protection by preventing:
• Impact hazards from chipping, grinding, machining, masonry work, riveting and sanding.
• Chemical hazards against liquids, acid and chemical handling, degreasing, plating.
NOTE: frequent cleaning due to lens fog may be required in certain conditions.
4. MAINTENANCE
4.1. CLEANING
Use a soft cloth and mild soap to clean. Ensure hands are clean (without grease).
9
DO NOT use abrasive materials.
8
4.2. STORAGE
Store in a bag or case out of direct sunlight, away from chemicals and abrasive substances, in a clean dust free environment.
9
Use original bag for transportation.
9
4.3. OBSOLESCENCE
Like all protective products, the life depends on the type of use, care and maintenance. If your frame is damaged, replace the entire
article. In every case, the product must be replaced after a period of two years.
© Jack Sealey Limited
SAFETY SPECTACLES
SSP66, SSP67, SSP68, SSP69
MODEL NO:
Original Language Version SSP66, SSP67, SSP68, SSP69 Issue 2 22/11/23