E13: Water Leaks - Electrolux 6 Series Service Manual
Hide thumbs
Also See for 6 Series:
- Service manual (84 pages) ,
- Service manual (66 pages) ,
- Service manual (76 pages)
Table of Contents
Advertisement
Guide to diagnostics of NEW COLLECTION EWM09312 electronic controls
E13
Maximum overall water fill time exceeded (sum of all water fills between one drain phase
Run the diagnostic cycle and fill all the trays with water (phases 2,3,4)
N
O
Is the drain pipe positioned
correctly and not causing the siphon
Is the washing machine's water
circuit efficient (leaking)?
Is the pressure switch's water circuit
efficient (leaking/clogged)?
Replace the circuit board and repeat the diagnostic cycle to check for any further alarms.
Is one or are all the solenoid valves
not working?
YES
Is the resistance measurement of the solenoid
valve approximately 3.5÷4.5 KΩ? (Measure it
directly on the solenoid valve without wiring)
–(see fig. 3)–
YES
Reconnect the connector and measure
approximately 3.5÷4.5 KΩ on the solenoid valve
wiring connector (on the circuit board side)
–(see fig. 4)–
Between J13-1 and J13-3 washing
Between J13-4 and J13-6 pre-wash
Is the solenoid valve wiring ok?
YES
Replace the circuit board and repeat the
diagnostic cycle to check for any further alarms.
T.S.-mdm FCPD-dp Quality tb
E13: Water leaks
and the next to avoid exceeding the maximum volume)
Are all the trays filling with water?
YES
effect? (fig. 1)
YES
YES
(fig. 2)
YES
!
Check that all the connectors are correctly inserted
Repair the drain circuit and repeat the
diagnostic cycle to check for any further
NO
Repair the water circuit and repeat
the diagnostic cycle to check for any
NO
Repair the water circuit of the pressure switch
and repeat the diagnostic cycle to check for
NO
any further alarms.
Check whether the tap is open, if the water
pressure is too low and make sure the tubes are
NO
connected and not kinked.
Replace the solenoid valve and repeat the
NO
diagnostic cycle to check for any further alarms.
Replace/repair the wiring and repeat the
NO
diagnostic cycle to check for any further alarms.
If there are burns on the circuit board,
!
20/61
alarms.
further alarms.
see page 59
599 74 42-27 Rev.00
E13
Advertisement
Table of Contents
