Table of Contents
Advertisement
Installation of the inverter on the enclosure
Push the inverter heat sink part outside the enclosure, and fix the inverter to the panel with upper and lower installation frames.
Inverter
NOTE
• As the heat sink part protruded through the panel includes a cooling fan, this type of installation is not suitable for the
environment of water drops, oil, mist, dust, etc.
• Be careful not to drop screws, dust etc. into the inverter and cooling fan section.
Enclosure
Inside the
Exhausted air
enclosure
There are finger guards behind the enclosure.
Therefore, the thickness of the panel should be
less than 10 mm (∗1) and also do not place
anything around finger guards to avoid contact
with the finger guards.
Installation
frame
10mm
Cooling
Dimension of
wind
the outside of
185mm
the enclosure
Enclosure
Finger guard
∗1
140mm
2.3 Installation of the inverter and enclosure design
2. INSTALLATION AND WIRING
1
2
3
4
5
6
7
8
9
10
35
Advertisement
Table of Contents
