Fujitsu UTY-LRHYA1 Installation Instruction Sheet

Receiver Kit
INSTALLATION INSTRUCTION SHEET
(PART NO. 9378782013-02)
For authorized service personnel only.
This mark indicates procedures which, if improperly performed, might lead to the death or serious injury of the
WARNING
user.
1 For the air conditioner to operate satisfactorily, install it as outlined in this installation instruction sheet.
2 Installation work must be performed in accordance with national wiring standards by authorized personnel only.
3 Do not turn on the power until all installation work is complete.
• • • • •
Let the customer keep this installation instruction sheet because it is needed when the air conditioner or receiver kit is
serviced or moved.
This mark indicates procedures which, if improperly performed, might possibly result in personal harm to the
CAUTION
user, or damage to property.
1 Do not wire the receiver kit wire together with or parallel to the connection cables, transmission cords, remote controller
cords, bus wire and power supply cords of the indoor and outdoor units. It may cause erroneous operation.
2 Do not install the receiver kit wire near a source of electromagnetic waves.
1 STANDARD PARTS
The following installation parts are supplied. Use them as required.
Name and Shape Q'ty Application
Receiver unit For receiving the signal
from the remote control
unit
1
Strap Prevent receiver kit from
falling down
1
Screw (ø3 × 12)
For installing remote
control unit holder to
wall
2
2 Insert the wire from the RECEIVER UNIT into the wiring hole as shown in the figure below and pull it into the Decoration
panel.
Wiring hole
Wire from RECEIVER UNIT
3 Hang the STRAP on the hook of the Decoration panel.
After that, mount the RECEIVER UNIT onto the Decoration panel.
Hook
Name and Shape Q'ty Application
Remote Use for air conditioner
control unit operation
1
Battery (penlight)
For remote control unit
2
Remote
Use as remote control
control
unit holder
unit holder
1
RECEIVER UNIT
Decoration Panel
Strap
2
FILTER LAMP
(RED)
TIMER LAMP
(ORANGE)
OPERATION LAMP
(GREEN)
MANUAL AUTO
SIGNAL RECEIVER
3 INSTALLING THE RECEIVER KIT
1. REMOVING THE CONTROL BOX COVER
1 Remove the screws.(2 places)
2 Slide the CONTROL BOX COVER in the direction of the arrow.
3 Remove the CONTROL BOX COVER.
CONTROL BOX COVER
2. INSTALLING THE RECEIVER UNIT
1 Mount the corner (figure to the drainpipe) of the decoration panel that has the "DISPLAY" mark onto the RECEIVER UNIT.
CAUTION
This corner must be mounted onto the RECEIVER UNIT.
3. WIRING
1 Connect the connector to the board in the CONTROL BOX.
2 Bundle the FLAP wires (2) to the RECEIVER UNIT wire as shown in the figure below.
Wire for FLAP
Wire for FLAP
Wire from RECEIVER UNIT
4. INSTALLING THE CONTROL BOX COVER
1 Secure the CONTROL BOX COVER in the procedure that is reverse to the steps in "1. REMOVING THE CONTROL BOX
COVER".
FUNCTIONS