Zanussi MW530D Instructions Manual page 6

WARNING
Connecting the supply cable to the
mains.
If you require a direct connection to the
electric network (mains) or the plug
cannot be reached (built in version), it
will be necessary to fit between the oven
and the mains an omnipole switch, with
a minimum aperture between contacts of
3 mm, suitable to carry the required load
and conforming to the ruling
specifications.
The green & yellow ground wire must
not be interrupted by the switch.
Prior to connecting the oven to the
electricity supply make sure that:
the protection fuse and the domestic
wiring system are suitable to carry the
total electric load of the appliance (see
rating plate):
the electricity supply network (mains)
has an efficient earth connection
according to the established rules and
existing regulations;
the double pole switch used to connect
the appliance to the supply is easily
accessible after installation.
The appliance must be earthed
Important: after installation and
connecting, the cable must be placed
that it cannot at any point reach a
temperature more than 50 °C above the
ambient temperature.
Warning: For reasons of safety it is
strictly forbidden to remove the rear
panel to gain access to the oven terminal
board; any extension should only be
made by using the standardized plug and
the external cable, and it should be
suitable to carry the expected load.
The manufacturers disclaim any
responsibility should these safety
instructions not be carried out
This appliance meets the requirements
laid down in EEC Directive No 82/499
dated 7/6/1982 relating to the
suppression of radio and TV interference.
6