Table of Contents
Advertisement
InfinityBoard Assembly Instruction
Connecting Cables
NOTE: Do not connect or disconnect cables when turning on the monitor's main power or other
external equipment's power as this may result in a loss of image.
NOTE: Do not use an attenuating (built-in resistor) audio cable. Use an audio cable without a built-in
resistor. Using an audio cable with a built-in resistor will lower the sound level.
Before making connections:
• Turn off the device's power before connecting it to the monitor.
• Refer to the device's user manual for available connection types and instructions for the device.
• We recommend turning off the monitor's main power before connecting or disconnecting a USB
storage device or a microSD memory card to avoid data corruption.
HUB
7
EXTERNAL
SPEAKER
TERMINAL
Internal/External
speaker switch
1. Enable the USB hub: Use the short 10 cm USB cable
supplied with the monitor. Connect USB cable from USB
Type-B input marked with "Hub" (located above external
speaker terminals) to USB Type-A input marked with "USB 1"
on the side of the monitor. The red LED on the USB hub will
light up.
NOTE: To enable USB 3.0 on USB ports on the USB hub you
need to connect the 3 m USB cable supplied with the monitor to
one of the USB 3.0 ports of the OPS slot-in PC.
NOTE: When connected to an external PC, use the 3 m USB
cable supplied with the monitor. Connect USB cable from USB
Type-B input marked with "Hub" to USB Type-A input of the
USB 1
external PC.
TOUCH
2. Enable touch: When used with an OPS slot-in PC no external
USB cable is needed to activate touch.
NOTE: When connected to an external PC, use the 3 m USB
cable supplied with the monitor. Connect from USB Type-B input
marked with "Touch" to USB Type-A input of the external PC.
13
Advertisement
Table of Contents
