Table of Contents
Advertisement
Overview
7
9
11
13
15
17
Rear Panel LEDs
The following figure shows the rear panel LEDs of the Secure Web Appliance S196 and describes their states.
The Secure Web Appliance S396 is the same except it has two power supplies. The Secure Web Appliance
S696 and S696F have the same LEDs except that these models have more data interfaces; the speed and status
LED descriptions are the same.
Figure 13: Rear Panel LEDs
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
10-Gigabit Ethernet SFP+ support
Note
The SFP-10G-SR (10 Gb) is the
only SFP+ transceiver qualified by
Cisco. Use only Cisco-qualified
SFPs.
Note
Copper SFPs are not supported.
USB 3.0 Type A (USB 2)
Data interface (DATA 2)
Not supported
Serial console port (Console)
RJ-45 connector that directly connects a
management computer to the appliance.
Unit identification button
1050-W AC power supply (PSU 2)
Cisco Secure Web Appliance S196, S396, S696, and S696F Hardware Installation Guide
8
USB 3.0 Type A (USB 1)
10
Data interface (DATA 1)
Not supported
12
RPC port (RPC)
Used for remote power cycling
14
VGA video port (DB-15 connector)
Not supported
16
1050-W AC power supply (PSU 1)
—
Rear Panel LEDs
15
Advertisement
Table of Contents
