Installation Notes; Installation Requirements; Surrounding Area; Electrical Connection - Miele PFD 401 U Installations Plan

Installation re-
quirements

Surrounding area

Protective sheet
for built-under ap-
pliances
Electrical connec-
tion
Plug connection
Hard-wired
Equipotential
bonding and
grounding

Installation notes

For safe installation and commissioning of the dishwasher, please
read the installation plan, the service documentation, and the oper-
ating instructions.
This installation plan includes the dimensions of the appliance, the
technical data, and the requirements to be met on site for the installa-
tion of the dishwasher.
Installation and commissioning work should be performed by a quali-
fied and trained service technician in accordance with local and na-
tional safety regulations.
Installation must comply with all local codes and regulations.
Condensate can build up in the area surrounding the dishwasher. Any
cabinetry and fittings in the room must, therefore, be suitable for this
purpose.
The protective sheet supplied protects the countertop from damage
caused by steam escaping when the door is opened. Fit the protective
sheet above the door, underneath the countertop.
All work on the electrical connection should be carried out by Miele
Customer Service, an authorized Miele dealer, or a qualified electri-
cian.
The dishwasher should be connected to the electricity supply via an
electrical outlet.
PFD 401, PFD 404: 208 V Configuration
Cord with plug is provided for use in commercial application only -
for installation observe your domestic electrical code.
If the dishwasher is hard-wired to the power supply, a circuit breaker
capable of disconnecting the dishwasher at all poles must be installed
on site. This power switch must have a contact gap of at least 1/8"
(3 mm).
The electrical socket outlet and the circuit breaker must be accessi-
ble after the appliance has been installed. This is to enable an electri-
cal safety test to be carried out after installation and after any servic-
ing work.
The power cord must be laid protected from the risk of thermal dam-
age.
This machine must be grounded in accordance with local code.
en - Installation notes
3