17. Measurement
17.1 Basic Operation
The basic operating procedures are common to all measurements.
CAUTION:
* The measurement switch function must have been registered on the main panel.
Contact your TOSHIBA representative for the registration procedure.
(1) After freezing the image, press the measurement switch. The registered
measurement function starts.
* To select other measurement functions, press
appears. Select the desired measurement from the menu and press
(2) Operate the trackball to move the mark on the screen to the start point of the
measurement region.
(3) Press
SET
(4) If necessary, place the cursor at the end point of the measurement region and
press
SET
(5) To perform another measurement using the same measurement function, press
.
NEXT
(6) After measurement is completed, press the measurement switch. The system
returns to normal ultrasound image display and the measurement results are
cleared.
1. The measured data is lost when image freeze is released
during measurement. (In the case of application
measurements, the data loss depends on the preset
settings.)
2. The measured data is lost when the system is turned OFF or
is pressed.
.
. The measurement result is displayed on the screen.
No. 2B730-973EN*D
17-1
. The measurement menu
MENU
.
SET